Diano sound follow robot kit can detect the direction of the sounds in the environment and move away from the audio source with this detection or go to the audio source.

Arduino codes of Diano sound follow robot are shared for free. Since these codes are open source code, you will be able to develop as you wish.

Thanks to the integrated L293D motor drive on the rocart card, it supports 600mA current per channel. It supports 7V - 14V voltage and reverse voltage protection is available. On the card, there is one buzzer, three LED, triple dip switch. Klamens connections do not require any soldering during assembly.

The installation time is between 20 and 40 minutes.

Note: There is no battery in the set.

Package Included :

• 1 x Diano Chassis
  
• 2 x Triple Female-Male Jumper Cable
  
• 2 x Sound Sensor Board - Microphone Sensor
  
• 1 x Arduino Nano Rokart Shield
  
• 1 x Arduino Nano Clone - with USB Cable - (USB Chip CH340)
  
• 2 x 6V Geared Micro DC Motor
  
• 4 x Two Different Color Short Cable
  
• 2 x Wheel
  
• 1 x Micro Drunk Caster
  
• 5 x Plastic Clamp
  
• 1 x 9V Battery Header