Robotistan RFID Starter Kit - Compatible with Arduino Uno

Radio Frequency Identification (RFID) is the general name given to technologies used to identify living beings or objects using radio waves.
There are many forms of identification, but the most common one is the use of a microchip (RFID tag) attached to an antenna that identifies a living being or object. Identification can be made more specific by adding other information that can be recorded on it.
The antenna allows the chip's identification information to be transmitted to a reader. The reader converts the radio waves received from the RFID tag into digital information, transfers it to the computer system, and makes this data usable.

The UNO RFID Starter Kit Compatible with Arduino brings together the Arduino® ecosystem with RFID technology, which supports the maker movement that started the individual production trend.
This way, you will be able to make identifications with radio frequencies thanks to the codes you write with your development board.
You will be able to easily overcome technologies like RFID, which many people hesitate to use, with the practicality offered by the Arduino® ecosystem.
All the components necessary for alerts, fasteners, and RFID technology found in the UNO RFID Starter Kit Compatible with Arduino are combined in a single box.

UNO RFID Starter Kit Compatible with Arduino Contents:

• 1 x USB Cable
• 1 x UNO R3 Development Board Compatible with Arduino
• 1 x 65-Piece Jumper Wire Set
• 1 x 830-Tie Point Breadboard
• 15 x LED (Red, Green, Yellow)
• 18 x Resistor (220R, 10K, 1K)
• 1 x 30-Pin Dupont Cable (Male-to-Female)
• 1 x Potentiometer
• 1 x Active Buzzer
• 1 x Passive Buzzer
• 1 x 74HC595N Shift Register IC
• 1 x Infrared (IR) Receiver
• 1 x LM35DZ Temperature Sensor
• 1 x Flame/Fire Sensor
• 1 x Tilt (Ball) Switch
• 3 x 5mm LDR (Photoresistor / Light Sensor)
• 4 x Push Button Switch with Cap
• 1 x IR Remote Control
• 1 x 1-Digit 7-Segment Display
• 1 x 4-Digit 7-Segment Display
• 1 x 8x8 Dot Matrix Display
• 1 x ULN2003 Driver Board and 28BYJ-48 Stepper Motor
• 1 x SG90 Servo Motor
• 1 x 1602 LCD (with I2C Module)
• 1 x PS2 Game Joystick Module
• 1 x DHT11 Temperature and Humidity Sensor Module
• 1 x Water Level Measurement Module
• 1 x RFID Module
• 1 x RFID Key Fob
• 1 x RFID Card
• 1 x Sound Sensor Module
• 1 x 1-Channel Relay Module
• 1 x RTC (Real-Time Clock) Module
• 1 x 4x4 (16-Button) Matrix Keypad Module
• 1 x RGB 3-Color LED Module
• 1 x 9V Battery Connector

Documents and Useful Links:

• Sample Application for RFID and Wireless Transmission
• Sample Application with Arduino® Mega 2560