Monster Moto Shield VNH3ASP30 (VNH2SP30 Stop Production) Stepper Motor Driver High Current 30A
- Features
- Payment Options
- Comments (0)
- Recommend
- Images
- Suggestion Box
-
Monster Moto Shield VNH3ASP30 (VNH2SP30 Stop Production) Stepper Motor Driver High Current 30A
Monster Moto Shield VNH3ASP30(VNH2SP30 Stop Production) High Current Stepper Motor Driver 30A is essentially an upgraded version of our Ardumoto motor driver shield. For this Monster Moto Shield, the L298 H-bridge has been replaced with a pair of VNH3ASP30 full-bridge motor drivers. Also, the booster circuit has been strengthened so this board can drive a pair of high current motors. The VIN and motor output are sloped for their 5mm screw terminals, making it easier to connect larger gauge wires. Motor Driver Shield is no longer available on Monster Moto as the L298 H-bridge has been replaced with a pair of VNH2SP30 full-bridge motor drivers. The Motor Driver Shield Monster Moto was developed to drive a pair of high current motors, while the VIN and motor were tuned to more easily connect larger wires. The VNH3ASP30 is a full-bridge motor driver designed for a wide variety of automotive applications. The device includes a dual monolithic high-side driver and two low-side switches. The high-side driver switch is designed using STMicroelectronics' well-known and proven proprietary VIPower M0 technology, which allows efficient integration on the same die of a true Power MOSFET with an intelligent signal/protection circuit. The VIN and motor output are pitched for 5mm screw terminals, making it easier to connect larger gauge wires. INA and INB control the direction of each motor and PWM pins turn motors on or off. For the VNH3ASP30, the current sensing (CS) pins deliver approximately 0.13V per amp of output current.
Monster Moto Shield High Current Stepper Motor Driver Pin Diagram:
Monster Moto Shield High Current Stepper Motor Driver Technical Specifications:
- Maximum Voltage: 16V
- Maximum Current Rating: 30A
- Practical Continuous Current: 14A
- It provides current detection for the Arduino analog pin.
- MOSFET on-resistance: 19 mΩ (per leg)
- Maximum PWM Frequency: 20kHz
- It provides thermal shutdown.
- It provides low voltage and over voltage shutdown.
- Driver Model: VNH3ASP30
- Operating Voltage (VDC): 12 ~ 16V
- Number of Channels: 2
- Battery Saver Mode: Yes
- LED Indicator: Yes
- Arduino Shield: Yes
- Weight: 19g
Monster Moto Shield High Current Stepper Motor Driver Connection Diagram:
Does Monster Moto Shield support direct RC inputs?
Does not directly support RC inputs.
Monster Moto Shield High Current Stepper Motor Driver Package Contents:
- 1 x Monster Moto Shield VNH3ASP30 (VNH2SP30 Stop Production) Stepper Motor Driver High Current 30A
Similar Products:Products That Can Be Used Together:
- Silicone Wire 8 Gauge 1 Meter Red/ 1 Meter Black
- XT60 Male to T Dean Female Plug Conversion Connector For Battery & Charger